Breeze 2 Pod for the Breeze 2 Kit from Aspire comes as a standard 3.0mL version. To remove the pod just squeeze the pod release buttons on each side of the device to release and remove the pod system. To re-insert, just place the pod back into the power unit, and push down firmly until it 'clicks' into place.
Coil installation is easy too, just pull and remove the drip tip, unscrew and pull out the chimney unit. Then detach the atomizer from the airflow control ring and replace it with a new one. Screw the chimney unit back to the pod system and replace the drip tip section. The Breeze 2 Pod comes pre-installed with a 0.6 ohm U-tech coil for your favorite e-liquid.
Squeeze the pod release buttons on each side of the device to release and remove the pod system. Invert the pod and lift the silicone seal, placing the filling bottle/dropper into the pod filling hole squeeze the filling bottle/dropper bulb to add your preferred e-liquid into the pod system. Replace the silicone seal firmly and re-insert the pod into the power unit.